INOX for Electrical
INOX for Electrical
THE ONLY LUBRICANT IN THE WORLD WITH THE SPECIAL MX3 ANTI-MOISTURE, ANTI-CORROSION FORMULA FOR THE 21ST CENTURY
US PAT. 5,614,479
INOX LUBRICANT IS A VERY VERSATILE, HIGH QUALITY PRODUCT
IN IT'S APPLICATION FOR THE LUBRICATION AND PROTECTION
FROM CORROSION AND MOISTURE FOR ALL ELECTRICAL AND
ELECTRONIC PARTS AND EQUIPMENT.
INOX is non-staining, non-corrosive, non-static and non-conductive, but does not effect the current flow when used in any electrical or electronic switches, plugs, circuits, fittings, parts or equipment.
SWITCHES, PLUGS AND LIGHT FITTINGS: Use INOX lubricant to penetrate corrosion and free up switches, bayonet & screw socket light globes, all light fittings, plugs & cable couplings, keeps this type of equipment corrosion free and in good serviceable order for up to 2 years. Spray INOX on screw socket type light fittings, it stops corrosion and makes globes easier to unscrew when replacing, Use INOX to protect against moisture and corrosion on refrigeration unit circuits & cable connectors & plugs used in sea, road and rail containers. Helps prevent short circuit arcing and earth leakage.
RELAYS, SOLENOIDS AND REGULATORS: Use INOX to keep relay, solenoid and regulator coils & circuits, contact arms & pivots lubricated and free from corrosion. INOX is very effective in stopping condensation in this type of equipment used cold storage rooms, freezing works, abattoirs, etc, dramatically reducing instances of short circuits and seizures caused by moisture and corrosion.
MOTORS, GENERATORS AND POWER BOARDS: INOX can be safely sprayed on field windings & armatures in motors and generators to protect them from moisture and corrosion, lubricates shaft bushes and small pin & ball bearings, helps prevents grounding and seizing. For protection from moisture and corrosion caused by condensation, spray INOX into cold room fan motors and exhaust fan motors used in high moisture areas. Use INOX on power board circuits as a preventive measure against moisture and corrosion, keeps power board relays and solenoids in good operating condition, free from moisture and corrosion.
CAUTION: INOX can be safely used on all direct, single and multi phase alternating and high tension currents with the one (1) exception: when using the INOX aerosol please allow a couple of minutes for the propellant gas (hydrocarbons) to dissipate before switching on the current. This procedure is not required for the non-pressurized packaged INOX.
INOX can be readily removed with most mineral based solvents. Dry cleaning fluid is the best, it's an evaporating non-flammable solvent, leaves no residue.
INOX ANTI-CORROSION LUBRICANT CAN BE USED FOR PROTECTION AGAINST ELECTROLYSIS, CORROSION AND CONDENSATIN FOR ALL ELECTRICAL AND ELECTRONIC CIRCUITS, PARTS AND EQUIPMENT.
INOX® QUALITY PRODUCTS