Shopping Cart
Your Cart is Empty
Quantity:
Subtotal
Taxes
Shipping
Total
There was an error with PayPalClick here to try again
CelebrateThank you for your business!You should be receiving an order confirmation from Paypal shortly.Exit Shopping Cart

JB ENTERPRISES

MX2 Battery Conditioner Applications and Uses

For all lead-acid batteries used in motor cars & cycles, boats & general marine, trucks, buses, farm & earthmoving machinery, stationary & generating plants, aviation, electric powered & driven machinery & equipment, isolated & independent transmitter & receiver installations, solar energy storage, emergency backup systems and all other industrial and commercial applications where lead-acid batteries are used.

Approximately 75% of lead-acid battery failures are caused by a buildup of sulphation on plates and separators. One treatment with MX2 Battery Conditioner dissolves and helps prevent the recurrence of this battery killing sulphation, restores the active ingredients and allows the battery to operate at full capacity.

MX2 Battery Conditioner will not harm batteries, it is purely an agent to help keep the electro-chemical process active longer in lead-acid batteries.

MX2 Battery Conditioner can be added to a battery at any age, the older a battery is, the less effective MX2 Battery Conditioner may be. If an older battery will not hold its charge properly, has recharging problems or is just generally slow, the addition of MX2 Battery Conditioner in 95% of cases will give the battery additional new life for up to 2 – 3 years.

No, MX2 Battery Conditioner is not a cure all, it will have little or no effect on mechanically unsound batteries.

DIRECTIONS FOR USE:

STANDARD BATTERIES UP TO 100 AMP HRS - MOTORBIKES:

12 VOLT         5 - 10 MLS/CELL

6 VOLT           10 - 20 MLS/CELL

STANDARD BATTERIES UP TO 100 AMP HRS - CARS, 4WD, ETC

12 VOLT 15 MLS/CELL

6 VOLT 30 MLS/CELL

TRUCKS, BUSES, MARINE, TRACTOR, ETC:

AMP HRS      VOLTAGE      MLS/CELL

101-150           6                     60

151-200           6                     60

201-300           6                    120

101-140           12                    30

141-180           12                    45

181-200           12                    60

Always add equal amounts of MX2 Battery Conditioner to each cell. If your battery size is not listed above, use 40 mls for every 1 liter of electrolyte. Your battery's capacity & AMP hour rating can usually be obtained from your local battery distributor.

NOTE: It is advisable to bring the battery up to full charge after adding MX2 Battery Conditioner either by driving or mechanical charger. 

If MX2 Battery Conditioner fails to bring new life to run down but mechanically sound battery, check the voltage regulator, generator, electrical switches and connections to make sure there is no electrical leak or short.

If your battery is not shown above, please click here to go to the CALCULATOR (scroll down about 1/3 of the way). Follow the directions for recommended amounts.

0