Gasoline Marine Medic
Gasoline Marine Medic
MATERIAL SAFETY DATA SHEET
Fuel Solutions Distributors LLC.
3777 N E 1631" Street #148
North Miami Beach Florida 33160
800 951 5430
May be used to comply with OSHA's Hazard Communication Standard 29CFR 1910.1200. Standard
SECTION I IDENTIFICATION
TRADE NAME: Gasoline Marine Medic
PRODUCT CODE: GMM-1192,
U.S.D.O.T. SHIPPING NAME: Combustible liquid, n.o.s.
TECHNICAL NAME: Petrochemical industry: Gasoline detergent additive
U.S.D.O.T. PRIMARY HAZARD CLASS: Non Regulated
U.S.D.O.T. SECONDARY HAZARD CLASS: Not Applicable
IDENTIFICATION NUMBER: NA1993
IATA (AIRLINE): Non Regulated
MARITIME NON: Regulated
PACKING GROUP: III
SECTION II HAZARDOUS INGREDEINTS - IDENTITY INFORMATION
HAZARDOUS COMPONENTS CAS # OSHA PEL ACGIH TLV
Solvent naptha (petroleum), light aromatic 64742-95-6 500ppm N/A
Benzene, 1, 2, 4 trimethylbenzene 95-63-6 N/A 25 ppm
Xylene 1330-20-7 N/A 100 ppm
Cumene 98-82-8 N/A 50 ppm
O-Xylene 95-47-6 N/A 100 ppm
N-Propylbenzene 103-65-1 N/A N/A
Benzene, 1, 2, 3-tri methyl benzene 526-73-8 N/A 25 ppm
Benzene, 1, 3, 5-trimethylbenzene 108-67-8 N/A 25 ppm
Polyolefin aikyl phenol alkyl amine Proprietary N/A N/A
2-Ethyl Hexanol 104-76-7 N/A N/A
Ethylhexylnitrate 27247-96-7 NA NA
Ethylene glycol monobutyl ether** 111-76-2 100 ppm 100 ppm
** Reportable under SARA 313 - 95% by weight
Other components, if any, are considered to be non-hazardous as per OSHA 29 CFR 1910.1200.
SECTION III PHYSICAL & CHEMICAL CHARACTERISTICS
FLASH POINT: 112°F Closed Cup (Pensky-Martens. Minimum)
SPECIFIC GRAVITY: 0.922 @ 20°C
VAPOR DENSITY (H20 = 1): Greater
VAPOR PRESSURE: 1.5 mmHg at 15.6/15.6C (target)
EVAPORATION RATE (BA = 1): Slower
% SOLIDS: Negligible
WEIGHT (lb./gal): 7.51
SOLUBILITY IN WATER: Slight
VISCOSITY @ 25 C: [email protected]°C
APPEARANCE & ODOR: Light Amber liquid, sweet amine odor
SECTION IV FIRE & EXPLOSION HAZARD DATA
EXTINGUISHING MEDIA: Dry chemical foam, or water fog.
SPECIAL FIRE FIGHTING PROTECTION: Protect against decomposition products. Wear Self Contained Breathing Apparatus.
UNUSUAL FIRE & EXPLOSION HAZARDS: Heating of non-vented container may cause explosion. Keep surrounding containers cool with water spray.
Hazardous Decomposition Products These products are carbon oxides (CO, CO2)
SECTION V REACTIVITY DATA
CONDITIONS TO AVOID: Contact with open flame.
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon Monoxide and unidentified organic compounds may be formed during combustion. Compounds may be formed during combustion
HAZARDOUS POLYMERIZATION: Will not occur.
SECTION VI HEALTH HAZARD DATA
SIGNS AND SYMPTOMS OF EXPOSURE:
EYES: Irritation, redness.
DERMAL: Dryness, irritation, redness.
INHALATION: Vapors may irritate nose, throat, respiratory tract.
INGESTION: Nausea, vomiting, dizziness, headache, blurred vision.
EMERGENCY AND FIRST AID PROCEDURES:
EYES: Flush with large amounts of water for 15 minutes.
DERMAL: Wash with soap and water.
INHALATION: Remove victim to fresh air.
INGESTION: Do Not induce vomiting. Get medical attention.
ACUTE HEALTH HAZARDS: Irritation of skin and eyes.
CHRONIC HEALTH HAZARDS: Observations in animals include blood, kidney and reproductive effects.
HAZARDOUS MATERIAL INFORMATION SYSTEM: Health 2
SECTION VII SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Dike area. Remove all sources of ignition. Ventilate area if necessary. Absorb free liquid with earth, sand, clay, or absorbent pads and place in non-leak containers for disposal. Flush area for trace residue and dispose of as below.
WASTE DISPOSAL METHOD: In accordance with Federal, State, and Local Laws.
SECTION VIII SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTION: Normally not needed in a well ventilated area.
VENTILATION: Mechanical to maintain good air flow.
PROTECTIVE GLOVES: Rubber.
EYE PROTECTION: Goggles or safety glasses.
OTHER: As needed to minimize exposure.
HYGENIC PRACTICES: Always wash face and hands after contact.
SECTION IX NOTES
The information contained herein is based on data considered accurate. However, no warranty is expressed or implied regarding the accuracy of this data or results to be obtained from the use thereof. Vendor assumes no responsibility for injury to vendee or third person proximately caused by the material if reasonable safety procedures are not adhered to as stipulated in the data sheet
Additionally, vendor assumes no responsibility for injury to vendee or third persons proximately caused by abnormal use of the material even if reasonable safety procedures are followed. Furthermore, vendee assumes the risk in the use of this material.
Revision date: January 5, 2009